![]() Nope, no addresses configured on any interface. First, I just checked to see if an address was assigned already: The next step that I took was to assign an IP Address to the VLAN 1 interface. Now, it’s time to configure it with an address:Īssign Ip Address to Dell PowerConnect Switch VLAN 1 Interface This will reset the switch to factory default settings. We do this by deleting the startup-config file and then reloading the switch as shown below: The next step after connecting with the terminal emulator was to reset the switch to factory default settings. ![]() Reset Dell PowerConnect Switch to Factory Settings This should get you connected to serial console. You can see the settings below that I found configured in my Dell PowerConnect switch: You will need to configure your terminal emulator’s line settings to 9600,8,n,1.
0 Comments
Leave a Reply. |